■
Worksite requirements for system components on page 65
1. Put the gas connect console in a position that obeys requirements for your cutting system
configuration and gas connect console type.
If you have questions about when or how to use the mounting holes, speak to your cutting machine
supplier or regional Hypertherm Technical Service team.
2. Use the mounting holes on the bottom panel to install the gas connect console as shown.
The following images show mounting-hole locations and dimensions by gas connect console type:
Figure 12 - Mounting-hole locations and dimensions for the
Core, CorePlus, and VWI gas connect console
1 Gas-inlet side
2 Gas-outlet side
* Correct orientation. Never install the gas connect console at an angle.
Installation
3
94
811530 Instruction Manual XPR460
To Next Page
Loading...
