Figure 47 - Plasma power supply and connection information in the web interface
Use network mode to connect
Use network mode to connect multiple plasma power supplies to a network. You can connect to and
control multiple plasma power supplies at the same time.
Before you begin:
■
You must have a computer-based device with a screen, a web browser that has support for the latest
web standards, and wireless access.
■
You must set up a router that has access to a local network. Use the instructions for the router to do
this. If you have problems setting up your router, speak to your system administrator.
■
You must know the SSID and passphrase for the router.
1. Use the procedure in Use AP mode to connect on page 169 to connect the wireless set-up device
to the plasma power supply.
2. Choose Connect on the Other screen to open the Device Setup screen.
The XPR web interface shows different fields for different models. The screen shown is for reference
only.
Connect for Communication
4
171811530Instruction ManualXPR460
To Next Page
Loading...
