WARNING
ELECTRIC SHOCK CAN KILL
The plasma power supply contains dangerous electric voltages that
can seriously injure or kill you. Even if the plasma power supply is
turned OFF, you can still get a serious electric shock if the plasma
power supply remains connected to an electric power source.
Use extreme caution if you do diagnosis or maintenance tasks when
the plasma power supply remains connected to an electric power
source and the outer cover or panels are removed. All work that
requires removal of the plasma power supply outer cover or panels
must be done by a qualified technician. Refer to the Safety and
Compliance Manual (80669C) for more safety information.
For your safety and for the best results:
■
Never operate the cutting system unless you are qualified to do so.
■
Follow NFPA70E Section 85 in North America.
■
Follow IEC 60364 series outside of North America.
■
Follow OSHA Section1910.331-335 in North America for 600 volts or less.
■
Follow all national and local electrical safety requirements for both operator and service personnel.
■
Always read, understand, and follow all of the safety instructions in this manual, the Safety and
Compliance Manual (80669C), and on the labels that are on the cutting system.
■
Get adequate operator training from a knowledgeable source before operation. Adequate training
topics include (but are not limited to) the following:
□
How to start and stop the cutting system during routine operation and in an emergency.
□
Conditions and actions that can cause injuries to people or damage cutting system equipment.
□
How to operate all controls.
□
How to identify and respond to fault conditions.
□
How to do maintenance.
□
A copy of the instruction manual.
■
Do not operate the cutting system if you cannot follow all of the safety instructions or if you cannot
satisfy the minimum operator qualifications. Refer to the Safety and Compliance Manual (80669C),
Radio Frequency Warning Manual (80945C), and Before you begin installation on page 79.
Additional qualifications apply for personnel who do maintenance and troubleshooting. Refer to
Qualifications of service personnel on page 43.
Qualifications and Requirements
2
42
811530 Instruction Manual XPR460
To Next Page
Loading...
