1 1.8 mm (3/16 inch)
2 Lower torch sleeve
3 Torch mounting bracket 5.72 cm (2.25 inches)
4 Torch receptacle
4. Move the torch assembly so that the torch mounting bracket is around the lower part of the torch
sleeve and does not touch the torch receptacle.
Make sure that the torch mounting bracket is as low as possible on the torch sleeve without touching
the torch receptacle. This position can keep vibration at the torch tip to a minimum.
5. Make sure that the torch is level (at a 0° angle) in all directions, as shown.
You can use a digital level to measure alignment for standard-position cutting, marking, and piercing.
Installation
3
148
811530 Instruction Manual XPR460
To Next Page
Loading...
