3. Connect End A of the serial RS-422 cable to the correct connector on the control PCB in the plasma
power supply:
□
For cutting systems with multiple plasma power supplies, use the top connector (J12) for the
CNC. Use the bottom connector (J13) to connect to the next plasma power supply.
□
For cutting systems with one plasma power supply, you can use either connector to connect to
the CNC.
4. Connect End B of the cable to the CNC.
5. If you want to operate the cutting system, continue with the next step.
If you want to only monitor with RS-422 serial, you are done.
6. Connect to the plasma power supply with discrete on page 162.
Figure 43 - Connect the serial RS-422 cable to the plasma power supply
Connect for Communication
4
158
811530 Instruction Manual XPR460
To Next Page
Loading...
