1 Coolant supply (green)
2 Coolant supply hose (green)
3 Coolant return (red)
4 Coolant return hose (red)
c. Attach compressed air (no more than 6.89 bar/100 psi) to the coolant return hose fitting on the
rear of the plasma power supply at the location where the return coolant hose (red band) was
connected before.
d. For no longer than 30 seconds, use the compressed air to blow all of the coolant back into to
the reservoir and filter housing.
The coolant is necessary to lubricate surfaces that must turn
freely. If air flows through the cutting system for longer than
30 seconds, it can remove the coolant that is necessary for
lubrication.
e. Close the valve at the bottom of the reservoir and remove the tube with the 3/8-inch inner
diameter from the outlet.
Do not keep the tube with the 3/8-inch diameter in the of the
plasma power supply.
f. Keep the coolant return hose (red band) disconnected from the rear of the plasma power
supply.
Maintenance
7
265811530Instruction ManualXPR460
To Next Page
Loading...
