You can do a gas leak test with all gas connect consoles, including Core and CorePlus.
Refer to Process-gas requirements for all gas connect consoles on page
48 for the recommended pressure and flow rates.
1. Use the CNC screen or XPR web interface to select the command to do an automated gas leak test.
The error log shows the test results.
The instruction manual that came with your CNC has information to help you do this step.
2. Refer to the error log for information about how to find or troubleshoot a possible gas leak.
Example
Gas leak tests in the XPR web interface
When you select GAS LEAK TEST in the XPR web interface:
1 The GAS LEAK TEST button is highlighted with red to show that it is active and the test has started.
2 The active valves are identified with colored highlights.
3 The gases shown on Line A, Line B, and shield are different for different process IDs. You can do a gas
leak test for Line A (black) and for Line B (yellow) but not for the shield gas line (blue).
4 The gases flow until you select the same button or select another button that interrupts the test.
Figure 67 - GAS LEAK TEST in the XPR web interface
Diagnostics and Troubleshooting
8
297811530Instruction ManualXPR460
To Next Page
Loading...
