Figure 11 - Example grounding diagram with a plasma cutting system (continued)
2 Gantry
3 Plasma system
4 Table ground bus bar
5 Gantry ground bus bar
6 Torch height control lifter
7 TorchConnect console
8 CNC
9 Torch height control module
10
Gas connect console. Connect to table ground bus bar.
1
11 DC power ground (work)
12 Cooler, if applicable
13 Chassis and EMI ground
14 Service ground
15 PE ground
1 The ignition console is integrated into the gas connect console for XPR cutting systems.
This example is based on practices in North America. Other regions can
have different national or local electrical codes. Hypertherm recommends
that you consult your national and local electrical codes to make sure
that the grounding and shielding practices that you use comply with the
requirements for your location.
Qualifications and Requirements
2
77811530Instruction ManualXPR460
To Next Page
Loading...
