WARNING
ELECTRIC SHOCK CAN KILL
The plasma power supply contains dangerous electric voltages that can seriously
injure or kill you. Even if the plasma power supply is turned OFF, you can still get
a serious electric shock if the plasma power supply remains connected to an
electric power source.
Use extreme caution if you do diagnosis or maintenance tasks when the plasma
power supply remains connected to an electric power source and the outer cover
or panels are removed.
WARNING
HYDROGEN GAS CAN CAUSE AN EXPLOSION OR FIRE
Hydrogen is a flammable gas that can cause an explosion or fire if it is not
removed.
Keep flames away from cylinders and hoses that contain hydrogen. Keep flames
and sparks away from the torch when using hydrogen as a plasma gas.
Consult your local safety, fire, and building code requirements for the storage and
use of hydrogen.
Hypertherm recommends that you install an exhaust ventilation system to remove
the hydrogen-enriched atmosphere that can collect when hydrogen is used as the
plasma gas for cutting.
Flashback arrestors are REQUIRED to stop the spread of fire to the supply gases
(unless a flashback arrestor is not available for a specific gas or pressure).
As an installer or user, you must supply the exhaust ventilation and flashback
arrestors for your cutting system. You can get them from your cutting machine
supplier.
Installation
3
81811530Instruction ManualXPR460
To Next Page
Loading...
