IBM i 830

Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
9302 Tape device failure or media error
The tape unit detected a failure that may be caused by a hardware failure
or a media error.
Refer to the tape unit service information for possible information on
diagnositic tests that can be run to isolate between hardware and media
failures.
MH7TMED
FI00871
9303 Gateway device failure
Use the gateway device service documenation to analyze the problem.
FCGATE
9310 Licensed Internal Code for the tape unit is not correct FI00130
FI00871
9320 Tape device Licensed Internal Code failure FI00130
FI00871
9321 Gateway device Licensed Internal Code error
Use the gateway device service documenation to analyze the problem.
FCCODE
9350 Tape unit detected a read or write error on tape medium
A permanent read or write error occurred. Clean the tape unit and retry
the operation.
If cleaning the tape unit does not correct the problem, exchange the tape
media.
MH7TMED
UH7CLN
FI00871
9351 Tape with excessive error rate was mounted in tape device.
The tape unit detected that the mounted tape cartridge has a history of
excessive read and write errors. It is recommended that you exchange the
tape cartridge.
MH7TMED
UH7CLN
FI00871
9355 The data format is incorrect; the tape cannot be read
The tape unit has detected that the data format on the tape media is not
supported.
Clean the tape unit and retry the operation.
If the operation continues to fail, use a different tape cartridge.
UH7USER
MH7TMED
UH7CLN
FI00871
9500 I/O processor Licensed Internal Code error
If the system is operational, take a dump of the I/O processor data. For
more information, see the iSeries Service Functions information or ask your
next level of support for assistance.
FI00130
9800 to 9803 I/O processor successfully recovered from temporary error
No action required. This reference code is logged for information only.
9810 Problem analysis has determined a part should be replaced.
This reference code is used for ending Online Problem Analysis with a list
of failing items. (Information Only)
9899 Problem analysis completed, the problem has been corrected.
This reference code is used for ending Online Problem Analysis when no
problem was found or the problem was corrected.
UH7FIXD
63A0
Chapter 2. Unit Reference Codes 159