IBM i 830

Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
1310 A problem occurred during the IPL of a secondary partition
The partition ID is characters 3 and 4 of the B2xx reference code in word 1
of the SRC. No alternate (D-mode) IPL IOP was selected. The IPL will
attempt to continue, but there may not be enough information to find the
correct D-mode load source.
Read and understand the information about logical partitions. See the
iSeries Service Functions information.
Have the customer configure an alternate IPL IOP for the secondary
partition. Then retry the secondary partition IPL.
LPARCFG
1320 A problem occurred during the IPL of a secondary partition
The partition ID is characters 3 and 4 of the B2xx reference code in word 1
of the SRC. No default load source IOP was selected for an A/B-mode IPL.
The IPL will attempt to continue, but there may not be enough information
to find the correct load source.
Read and understand the information about logical partitions. See the
iSeries Service Functions information.
Have the customer configure a load source IOP for the secondary partition.
Then retry the secondary partition IPL.
LPARCFG
3110 A problem occurred during the IPL of a secondary partition
The partition ID is characters 3 and 4 of the B2xx reference code in word 1
of the SRC. Contact your next level of support.
LPARSUP
3113 A problem occurred during the IPL of a secondary partition
The partition ID is characters 3 and 4 of the B2xx reference code in word 1
of the SRC. Read and understand the information about logical partitions.
See the iSeries Service Functions information.
Look in the Service Action Log of the Primary partition for B600xxxx SRCs
that were logged when the secondary partition was IPLing. Correct the
B600xxxx problem, then retry the secondary partition IPL.
If there are no B600xxxx SRCs in the Service Action Log of the Primary
partition from the secondary partition’s IPL then contact your next level of
support.
LPARSUP
3114 A problem occurred during the IPL of a secondary partition
The partition ID is characters 3 and 4 of the B2xx reference code in word 1
of the SRC. Read and understand the information about logical partitions.
See the iSeries Service Functions information.
Look in the Service Action Log of the Primary partition for B600xxxx SRCs
with the same bus/board/card numbers identified in the B2xx xxxx SRC
words. Use the new SRC and go to “Chapter 2. Unit Reference Codes” on
page 59.
The B2xx xxxx SRC Format is Word 1: B2xx3114, Word 3: Bus, Word 4:
Board, Word 5: Card.
FI00096
3120 A problem occurred during the IPL of a secondary partition
The partition ID is characters 3 and 4 of the B2xx reference code in word 1
of the SRC. Retry count exceeded. Contact your next level of support.
LPARSUP
B2xx
Chapter 2. Unit Reference Codes 209