Reference
Code
Description/Action Perform all actions before exchanging
Failing Items
Failing Item Location
0103 Main storage dump must be copied for service.
Perform “LIC-PIP1” on page 342.
0104 Terminate Immediate reference code is bad
Perform “LIC-PIP8” on page 349.
AJDG301
0105 More than one request to terminate the system was issued
Perform “LIC-PIP8” on page 349.
AJDG301
0106 Terminate Immediate data is not valid
Perform “LIC-PIP8” on page 349.
AJDG301
0202 Unrecoverable read error
Restore the Licensed Internal Code using “Licensed Internal
Code Install and Restore” in the iSeries Service Functions
information.
0244, 0255, 0266 Contact was lost with the device indicated
Do not power off the system.
Perform “LIC-PIP13” on page 368.
FI00580
FI00500
FI00302
FI00301
AJDG301
0277 A compression disk unit cannot complete an operation.
Note: Do not power off the system when performing this
procedure.
Look at the 4 leftmost characters of the Data display for word
7. These four characters indicate the type of problem that exists
and the recovery action to perform.
If these characters are 8402 or 2002, the compression disk unit
is temporarily full of data. The command to the compression
disk is being held. When the storage subsystem controller has
created sufficient space on the compression disk unit to contain
the data, the command which is being held will be released and
the system will resume normal processing. If the system does
not resume normal processing within 20 minutes, contact your
next level of support.
If these characters are 8400 or 2000, the compression disk unit
is full of data. The command to the compression disk is being
held. Ask the customer to perform the recovery actions in the
″Disk Unit Full Considerations″ section of the Backup and
Recovery Guide, SC41-5304.
0302 Recursion in exception handler
Perform “LIC-PIP8” on page 349.
AJDG301
0304 Component specific exception handler return code not valid
Perform “LIC-PIP8” on page 349.
AJDG301
0305 Exception while storage management lock is held
Perform “LIC-PIP8” on page 349.
AJDG301
B6xx (including A6xx)
Chapter 2. Unit Reference Codes 241
To Next Page
Loading...
Need help?
General