Reference
Code
Description/Action Perform all actions before exchanging
Failing Items
Failing Item Location
7204 Uninterruptible Power System reported a bypass active
This reference code is for information only. The Uninterruptible
Power System (UPS) is reporting a bypass is active.
7205 Battery low condition was reset.
This reference code is for information only. The Uninterruptible
Power System (UPS) is no longer reporting a battery low
condition.
7206 UPS reported bypass no longer active
This reference code is for information only. The Uninterruptible
Power System (UPS) is no longer reporting a bypass active
condition.
7207 Battery Power Unit needs service
The replacement period for BPU 1, installed in the System Unit,
has been exceeded.
7208 Battery Power Unit needs service
The replacement period for BPU 2, installed in the System Unit,
has been exceeded.
7209 Battery Power Unit needs service
The replacement period for BPU 1, installed in the Expansion
Unit, has been exceeded.
720A Battery Power Unit replacement dates do not match
The replacement dates for one of the Battery Power Units do
not match. Run ″Display Hardware Configuration″ and verify
that the dates match the labels on the batteries.
7701 SCSI jumper card was not detected. 21H7625
BACKPLN
7702 Incorrect SCSI jumper card detected 21H7625
7703 System LIC detected a program exception
Storage Management detected a DASD datacheck condition and
the defective sector was reallocated.
Perform a system IPL to restart the system.
7704 General failure detected by HRI component. AJDG301
B6xx (including A6xx)
Chapter 2. Unit Reference Codes 273
To Next Page
Loading...
Need help?
General