IBM i 830

7. Use the ″Accept load source disk unit″ option to accept the new load source into
the current partition.
a. Go to SST/DST in the current partition and select option ″Work with system
partitions″.
b. From the ″Work with system partitions″ screen select option ″Recover
configuration data″.
c. From the ″Recover configuration data″ screen select option ″Accept load source
disk unit″.
This ends the procedure.
8. Are there multiple B600 5311 SRCs logged in the same partition?
Yes No
↓ None of the conditions in this procedure have been met, call your next
level of support.
This ends the procedure.
9. Is the resource for one of the B600 5311 SRCs the load source device and are all
of the other B600 5311 entries for resources which are non-configured disk
units?
Note: To determine if a disk unit is a non-configured disk unit, refer to the
″Work with disk unit options″ section in the ″DST options″ section of the
″DST chapter″ in the iSeries Service Functions information.
Yes No
↓ Go to step 16 on page 378 of this procedure.
10. Is the partition that is reporting the error the Primary partition?
Yes No
↓ Go to step 14 on page 378 of this procedure.
11. Was the load source disk unit migrated from another partition within the
same system?
Yes No
↓ The load source disk unit has not changed. Contact your next level of
support.
This ends the procedure.
12. Is this load source device intended to be the load source for the Primary
partition?
Yes No
↓ Power off the system. Return the original load source disk to the
Primary partition and perform a system IPL.
This ends the procedure.
13. Use the ″Accept load source disk unit″ option to accept the new load source into
the current partition.
a. Go to SST/DST in the current partition and select option ″Work with system
partitions″.
b. From the ″Work with system partitions″ screen select option ″Recover
configuration data″.
LPAR PIPs
Chapter 3. Problem Isolation Procedures (PIPs), Failing Items, and Symbolic FRU Isolation 377