IBM i 830

7. Does the Disk Configuration Error Report display or the Disk Configuration
Warning Report display appear on the console?
No Yes
↓ Select option 5, then press F11, then press the Enter key to display the
details.
If all of the reference codes are 0000, go to “LIC-PIP 11” on page 350
and use cause code 0002. If any of the reference codes are not 0000, go
to step 11 of this procedure and use the reference code that is not
0000.
Note: Use the characters in the Type column to find the correct
reference code table.
8. Look at the product activity log (see “Product Activity Log” in the iSeries
Service Functions information).
Is an SRC logged as a result of this IPL?
Yes No
↓ The problem cannot be isolated any more. Use the original SRC and
exchange the failing items. Start with the highest probable cause of
failure (see the failing item list for this reference code in “Chapter 2.
Unit Reference Codes” on page 59 and “Chapter 4. Removal and
Installation Procedures” on page 617). If the failing item list contains
FI codes, see “Failing Items” on page 479 to help determine part
numbers and location in the system.
This ends the procedure.
9. Does the Disk Configuration Error Report display or the Disk Configuration
Warning Report display appear on the console?
No Yes
↓ Select option 5, then press F11, then press the Enter key to display the
details.
If all of the reference codes are 0000, go to “LIC-PIP 11” on page 350
and use cause code 0002. If any of the reference codes are not 0000, go
to step 11 of this procedure and use the reference code that is not
0000.
Note: Use the characters in the Type column to find the correct
reference code table.
10. Look at the product activity log (see “Product Activity Log” in the iSeries
Service Functions information).
Is an SRC logged as a result of this IPL?
Yes No
↓ The problem is corrected.
This ends the procedure.
11. Record the SRC on the Problem Summary Form (see “Appendix A. Problem
Summary Form” on page 951).
Are the SRC and unit reference code (URC) the same ones that sent you to
this procedure?
Yes No
SDIOP PIPs
402
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1