5. Is the Frame ID 1?
No Yes
↓ Go to step 2 on page 705 of this procedure.
6. The Frame ID is the hexadecimal representation of the decimal number
displayed on the panel of the unit or rack.
Note: If the tower unit is an xSeries Server (formerly known as Netfinity
Server), the Frame ID will be displayed on the 2689 adapter card located
inside the tower unit (to find the card follow the SPCN or HSL cables
that connect to the card). You will need to remove the cover on the
xSeries Server to view the Frame ID.
Attention: Refer to the xSeries Server service documentation prior to
removing any covers or cards from the xSeries Server.
Find the unit or rack that displays this number. Then, find the unit or rack
diagram that matches this hardware.
v For Migrated Tower diagrams, see Migrated Expansion Tower Problem Analysis,
Repair and Parts, Repair and Parts.
v For rack diagrams, see SY44-4934-00, FC 504x Problem Analysis and Repair
and Parts information.
v All other tower diagrams:
– If you have location information (card or device position), go to
“Locations and Addresses” on page 705 and find the location diagram that
matches this hardware. Each diagram has a table that indicates how to get
part number information and which Removal and Installation/Recovery
procedure to perform.
– If you only have address information (Direct Select Address and Unit
Address), find the address diagram that matches this hardware. Use the
diagram to find the location. Then, go back to “Locations and Addresses”
on page 705 and find the location diagram that matches this hardware.
Logical Hardware Resources on System Bus
System bus(es) to work with...... 6 *ALL, 1- 7
Subset by............... *ALL *ALL, *STG, *WS, *CMN
Type options, press Enter.
2=Change detail 4=Remove 5=Display detail 6=I/O Debug
8=Associated packaging resource(s) 9=Resources associated with IOP
Resource
Opt Description Type-Model Status Name
_ System Bus - Operational BUS02
8 Storage IOP 6512-001 Operational SI04
_ Storage IOP 6512-001 Operational SI05
F3=Exit F5=Refresh F6=Print F9=Failed resources
F10=Non-reporting resources F11=Display serial/part numbers F12=Cancel
Figure 27. Example Display Only
Locations and Addresses
Chapter 5. Locations, Addresses, and Part Listings 707
To Next Page
Loading...
Need help?
General