2014-03-24
No Watchman LED
Button
State
상세
설명
8
Check Please..
Ribbon Not Found
RED
Blink
Ribbon
Research
Ribbon is not installed or
not searched
Fail to ribbon search. Check the ribbon installed status and if there is nor ribbon,
please reinstall ribbon in printer.
9
Check Please..
Ribbon Zero
RED
Blink
Ribbon
Research
All ribbons are used
Ribbon remains is zero. Need to change the ribbon. If pressing button, SMART-
30 search ribbon again.
10
Check Please..
TPH Not Found
RED
Blink
Thermal Print Head is
not installed
When the thermal Print Heat is not installed or disconnected to head cable, this
message is displayed. Please power off SMART printer and check the thermal
head installation status.
11
Card Out Error
< Cancel >
RED
Blink
Initializing
Card Out Error
(Check card in Printer)
When there is printing error , the card is not ejected after pressing button.
12
Board Test Mode
Wait
RED
Blink
Printer Test Mode SMART-30 is on test mode that the sensors and motors of printer are tested.
14
1.1 Printer Basic Information
To Next Page
Loading...
