idp Smart-30 - Printer Status and Error Codes

2014-03-24
90
4.2 Test
4.2.4 Status
4.2.4.1 Printer Status Code
SMSC_M_CARDIN 0x0000000000000001 // Under Card In
SMSC_M_CARDOUT 0x0000000000000002 // Under Card Out
SMSC_M_MOVE_PRINT 0x0000000000000004 // Move to Printing Position
SMSC_M_MOVE_PRN2ROT 0x0000000000000008 // Move to Flipper from Printer
SMSC_M_MOVE_ROT2PRN 0x0000000000000010 // Move to Printer from Flipper
SMSC_M_MOVE_IC 0x0000000000000020 // Move to IC Position
SMSC_M_MOVE_RF 0x0000000000000040 // Move to RF Position
SMSC_M_MOVE_MAG 0x0000000000000080 // Move to Magnetic Stripe Position
SMSC_M_THUP 0x0000000000000100 // Thermal Print Head Up
SMSC_M_THDOWN 0x0000000000000200 // Thermal Print Head Down
SMSC_M_ICHUP 0x0000000000000400 // IC Head (Contactor) Up
SMSC_M_ICHDOWN 0x0000000000000800 // IC Head (Contactor) Down
SMSC_M_PRINT 0x0000000000001000 // Under Printing
SMSC_M_MAGRW 0x0000000000002000 // Magnetic Stripe Read/Write
SMSC_M_SEEKRIBBON 0x0000000000004000 // Searching Ribbon
SMSC_M_MOVERIBBON 0x0000000000008000 // Moving Ribbon
SMSC_M_ROTATORTOP 0x0000000000010000 // Card Front Side Flipping to Up
SMSC_M_ROTATORBOTTOM 0x0000000000020000 // Card Front Side Flipping to Down
SMSC_S_HOPPERHASCARD 0x0000000000040000 // Card is in the Hopper
SMSC_S_CLEANWARNING 0x0000000000080000 // Need to cleaning State (After firmware 1.00.60)
SMSC_S_CARDIN 0x0000000000100000 // Card Detection by Card In Sensor
SMSC_S_CARDOUT 0x0000000000200000 // Card Detection by Card Out Sensor
SMSC_S_EQUIPLAMINATOR 0x0000000000400000 // Laminator is installed (After firmware 1.00.60)
SMSC_S_EQUIPROTATOR 0x0000000000800000 // Flipper is installed
SMSC_M_RECVPRINTDATA 0x0000000001000000 // Receiving Printing Buffer
SMSC_S_HASPRINTBUFFER 0x0000000002000000 // Reserving Printing Data Buffer
SMSC_M_SBSRUNNING 0x0000000004000000 // Doing SBS Command
SMSC_S_SBSMODE 0x0000000008000000 // SBS Mode State
SMSC_S_CASEOPEN 0x0000000010000000 // Case Open State
SMSC_M_INIT 0x0000000020000000 // Under Initialization
SMSC_S_TESTMODE 0x0000000080000000 // Test Mode State