idp Smart-30 - Page 91

2014-03-24
91
4.2 Test
Status codes are changed after Printer firmware 1.00.60 as below.
SMSC_S_CLEANWARNING 0x0000000000080000 // Need to cleaning State (After f/w 1.00.60)
SMSC_S_THUP 0x0000000000080000 // Thermal Print Head Up state (Before f/w 1.00.60)
SMSC_S_EQUIPLAMINATOR 0x0000000000400000 // Laminator is installed (After f/w 1.00.60)
SMSC_S_ROTATORTOP 0x0000000000400000 // Card Front Side is up at Rotator (Before f/w 1.00.60)