2014-03-24
58
• Overlay Printing Thickness
Overlay is coating to the surface of card for the protection of printing image. Usually the overlay print all over
the card surface but it can be printed in specific area by the device driver or Smart Design software.
Overlay is binary type such as black resin, print or not. So the setting standard of printing thickness is different.
If it is too strong, it is too dull and can be occurred the bad overly such as left figure. And if too weak, some
area will not be overlaid. You can check it if place the card under light. So set the overlay printing thickness
properly. Not too strong but a little bit strong is best.
Too Strong Proper Too Weak
4.1 Setup
To Next Page
Loading...
