idp Smart-30 - Basic Setup Items Table

2014-03-24
49
4.1 Setup
Item Explanation
Device
Available device list will be displayed. “SMART” is printer ID value. “I&A SMART Card Printer”
is the printer driver name. Using the printer ID, the printer can be distinguish when you
use SDK.
Change Password Change password
Firmware Ver. The printer’s firmware version
Serial No. The printer’s serial no.
Header Serial No.
The printer’s Thermal Print Head serial no. When the thermal print head is change, it
should be changed.(See 4.1.3.6)
Header Resister
The resistor value of the thermal print head. When the thermal print head is change, it
should be changed.
Head Type Set type of thermal print head.
X Start Position
Adjust X start position (Range : -30 ~ 30)
※ If the value is change, the example will be changed. (See 4.1.3.1)
Y Start Position
Adjust Y start position. (Range : -30 ~ 30)
※ If the value is change, the example will be changed. (See 4.1.3.1)
Y End Position
Adjust Y end position (Range : -20 ~ 20)
※ If the value is change, the example will be changed. (See 4.1.3.1)
Y Scale
Adjust the length of image (Range : -60 ~ 60)
※ If the value is change, the example will be changed. (See 4.1.3.1)
Total Density Set the image’s total density (Range : -500 ~ 500) (See 4.1.3.2)
YMC Density Set the color density (YMC) (Range : -500 ~ 500) (See 4.1.3.2)
• Basic Setup Item