idp Smart-30 - Printer Testing Procedures

2014-03-24
74
4.2 Test
4.2.1 Overview
CardPrinterTest is to test the all function of SMART Card Printer. To operate CardPrinterTest program, the device
driver should be installed to PC and SMART printer should be connected.
Card Printer use the standard printer device driver so it can be printed same as general printer. However if there is
encoder, it need to install the driver which the encoder is required. In this case the printer’s detailed operation can
be controlled using “Card Printer SDK.” CardPrinterTest program is developed by “Card Printer SDK”.
CardPrinterTest is consist of Choice, Control, Print, Allocation, Encode, State, Message.
①Select : Choose the printer when there is more than one printer is connected.
②Control : Order the command such as Card In, Out, Move and Rotate.
③Print : Print the image.
④Allocation : Set the encoding number.
⑤Encoding : Do magnetic stripe encoding, Smartcard and Contactless Smartcard encoding.
⑥State : Check the printer’s state.
⑦Message : Display all kinds of message which displayed when use CardPrinterTest.
4.2 Test