2014-03-24
52
4.1 Setup
Item Explanation
Change Printer ID When use SDK, this ID can be used to distinguish each printer (See 4.1.3.8)
Set PC Serial When use PC Authentication, set the PC to print (See 4.1.3.7)
Change Head In case of changing thermal print head, set the serial no. and resistor value (See 4.1.3.6)
Set Mag. Encrypt Key When transport the magnetic data and if it is encrypted, you can set the Key (See 4.1.3.7)
T
o
t
a
l
I
s
s
u
e
Image Total printed image number
Magnetic Total magnetic encoding number
IC Total Contact Smartcard encoding number (It can be increasing by SDK)
SIM Total Contact Smartcard(SIM) encoding number (It can be increased by SDK)
External RF Total RF Smartcard(external) encoding number (It can be increased by SDK)
Internal RF Total RF Smartcard(internal) encoding number (It can be increased by SDK)
Printed Panels Printed panel number for the image printing
Cleaning Count Total printed panel number and magnetic encoding number for checking cleaning cycle.
Skipped Cleaning After demanding clean warning, skipped cleaning number
U
s
e
r
I
s
s
u
e
Image After installing new head, printed image number
Magnetic After installing new head, magnetic encoding number
IC After installing new head, Contact Smartcard encoding number (It can be increasing by SDK)
SIM After installing new head, SIM Smartcard encoding number (It can be increased by SDK)
External RF After installing new head, RF card(external) encoding number (It can be increased by SDK)
Internal RF After installing new head, RF card(internal) encoding number (It can be increased by SDK)
Cleaning Count
After installing new head, printed panel number and magnetic encoding number for
checking cleaning cycle.
Skipped Cleaning After installing new head and demanding clean warning, skipped cleaning number
• Expansion Setup Item
To Next Page
Loading...
