Intel Stratix 10 User Manual

16. Read 0x8B[0], until it changes to 0.
17. Write 0x8A[7] to 1 to clear the 0x8A[7] flag.
Load the value to the PMA parameter by setting the PMA attribute code 0xEC to PMA
attribute value 0x15.
18. Write 0x84[7:0] = 0x15.
19. Write 0x85[7:0] = 0x00.
20. Write 0x86[7:0] = 0xEC.
21. Write 0x87[7:0] = 0x00.
22. Write 0x90[0] = 1'b1.
23. Read 0x8A[7]. It should be 1.
24. Read 0x8B[0], until it changes to 0.
25. Write 0x8A[7] to 1 to clear the 0x8A[7] flag.
Set the PMA parameter so that it is not overwritten by the adaptive tuning engine by
configuring the PMA attribute code 0x2C to attribute value 0x108 and PMA attribute
code 0x6C to attribute value 0x20.
26. Write 0x84[7:0] = 0x08.
27. Write 0x85[7:0] = 0x01.
28. Write 0x86[7:0] = 0x2C.
29. Write 0x87[7:0] = 0x00.
30. Write 0x90[0] = 1'b1.
31. Read 0x8A[7]. It should be 1.
32. Read 0x8B[0], until it changes to 0.
33. Write 0x8A[7] to 1 to clear the 0x8A[7] flag.
34. Write 0x84[7:0] = 0x20.
35. Write 0x85[7:0] = 0x00.
36. Write 0x86[7:0] = 0x6c.
37. Write 0x87[7:0] = 0x00.
38. Write 0x90[0] = 1'b1.
39. Read 0x8A[7]. It should be 1.
40. Read 0x8B[0], until it changes to 0.
41. Write 0x8A[7] to 1 to clear the 0x8A[7] flag.
Refer to the Register Map for more details. Further information about configuring
PMA parameters will be available in a future release of this user guide.
Related Information
Register Map on page 165
8. Dynamic Reconfiguration Examples
UG-20056 | 2019.02.04
Intel
®
Stratix
®
10 E-Tile Transceiver PHY User Guide
Send Feedback
156

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English