A. E-Tile Channel Placement Tool
Intel Stratix 10 E-Tile supports Data Centers, 5G networks, Smart Grid and other
market segments. Ethernet, CPRI and OTN are the backbone of these emerging and
traditional technologies. The E-Tile Channel Placement Tool, in conjunction with the
Intel Stratix 10 GX, MX, TX, and SX Device Family Pin Connection Guidelines, allows
you to swiftly plan protocol placements in the product prior to reading comprehensive
documentation and implementing designs in Intel Quartus Prime.
The Excel-based E-Tile Channel Placement Tool, supplemented with Instructions,
Legend, and Revision tabs, is self-sustaining and available for download at E-Tile
Channel Placement Tool.
Figure 101. E-Tile Channel Placement Tool
Related Information
Intel Stratix 10 Device Family Pin Connection Guidelines
A.1. E-Tile Channel Placement Tool Revision History
Document
Version
Changes
2019.02.04 Made the following changes:
• Added information for clocking fractured FEC
• Added new protocol: Channel PLL
• Updated PAM4 protocol formatting
2018.05.15 Made the following changes:
continued...
UG-20056 | 2019.02.04
Send Feedback
Intel Corporation. All rights reserved. Intel, the Intel logo, Altera, Arria, Cyclone, Enpirion, MAX, Nios, Quartus
and Stratix words and logos are trademarks of Intel Corporation or its subsidiaries in the U.S. and/or other
countries. Intel warrants performance of its FPGA and semiconductor products to current specifications in
accordance with Intel's standard warranty, but reserves the right to make changes to any products and services
at any time without notice. Intel assumes no responsibility or liability arising out of the application or use of any
information, product, or service described herein except as expressly agreed to in writing by Intel. Intel
customers are advised to obtain the latest version of device specifications before relying on any published
information and before placing orders for products or services.
*Other names and brands may be claimed as the property of others.
ISO
9001:2015
Registered
To Next Page
Loading...
Need help?
General
