Intel Stratix 10 User Manual

8.12. Configuring a PMA Parameter Using Native PHY IP
8.12.1. PMA Bring Up Flow Using Native PHY IP
Figure 92. Configuring a PMA Parameter Using Native PHY IP Flow Chart
Select the desired test configuration for your datarate and channel loss profile
2
Generate design using the PMA Adaption section of the Native PHY IP GUI
to pick the PMA configuration(s) you wish to use with your design
1
Save and generate the IP and then compile the design
Multiple test configurations can be set for all channels of a Native PHY instance
Program the device with the resulting .sof
Open the System Console and link the design
Transceiver PMA Bring Up is user triggered and requires configuring a few registers
3, 4, 5
The transceiver PMA is set to the selected test configuration
Note:
1. Refer to "PMA Adaptation" for PMA Adaptation Tab details.
2. Refer the "PMA Adaptation Options" table for details.
3. Refer to "PMA Bring Up Flow."
4. Refer to "PMA Parameters."
5. Refer to the "Configuring a PMA Parameter Using Native PHY IP" design example for details.
Related Information
• PMA Parameters on page 29
• PMA Adaptation on page 37
8. Dynamic Reconfiguration Examples
UG-20056 | 2019.02.04
Send Feedback
Intel
®
Stratix
®
10 E-Tile Transceiver PHY User Guide
157

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English