Intel Stratix 10 User Manual

Related Information
• PMA Attribute Details on page 129
• PMA Attribute Codes on page 170
• Reconfiguring the Duplex PMA Using the Reset Controller in Automatic Mode on
page 140
5.1. PMA Calibration Revision History
Document
Version
Changes
2019.02.04 Made the following changes:
• Added link to Reconfiguring the Duplex PMA Using the Reset Controller in Automatic Mode.
• Added reminder: Refer to PMA Attribute Codes for information on which attributes can only be
changed when the PMA is disabled.
2018.07.18 Made the following changes:
• Added instructions to PMA Calibration: When dynamically reconfiguring the PMA to a different
datarate, you need to recalibrate the PMA. The PMA calibration is run when the PMA is enabled, so
you first disable the PMA.
• Added the "Wait for tx_pma_ready and rx_pma_ready ports to assert" block to the "Enabling PMA
Calibration" figure.
2018.05.15 Made the following changes:
• Added instructions to enable/disable the PMA using PMA attribute code 0x0001.
• Added the "Changing a Setting When the PMA Cannot be Running" flowchart.
2018.01.31 Initial release.
5. PMA Calibration
UG-20056 | 2019.02.04
Send Feedback
Intel
®
Stratix
®
10 E-Tile Transceiver PHY User Guide
99

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English