Intel Stratix 10 User Manual

Document
Version
Changes
• Added Configuring a PMA Parameter Using Native PHY IP.
• Added a step to Reconfiguring the Duplex PMA Using the Reset Controller in Automatic Mode:
Deassert tx_reset/rx_reset.
2018.10.08 Made the following changes:
• Changed the steps in the "Reconfiguring the Duplex PMA Using the Reset Controller in Automatic
Mode" section.
• Changed the bit range in the "PMA Attribute Code Error Inject Bits" table.
• Added Step 9 to the "Configuring the Attenuation Value" section.
• Added Step 9 and Step 18 to the "Configuring the Post Emphasis Value" section.
• Added the "Example Use Case to Configure PMA Parameters" section.
• Removed the "Reading 32-bit Errors" section.
• Removed one-time adaptation from PMA Receiver Equalization Adaptation Usage Model.
• For Configuring the Post Emphasis Value, added the option to set it to -2 (decimal) and 0xFE
(hexadecimal).
• Updated step #7 (resetting the internal controller) in Reconfiguring the Duple PMA Using the Reset
Controller in Automatic Mode.
• Added Configuring a PMA Parameter Tunable by the Adaptive Engine.
2018.07.18 Made the following changes:
• Added three new topics: Reading 32-bit Errors, Configuring TX Polarity for the PMA Driver, and
Configuring RX Polarity for the PMA Driver.
• Switched the order of all write commands and added the step to "Write 0x8A[7] to 1 to clear the
0x8A[7] flag" in User-Defined Pattern Example.
• Added Configuring the Attenuation Value (VOD).
• Added Configuring the Post Emphasis Value.
•
Added Configuring pretap1 Values.
• Changed the names of the adaptive equalization modes in the PMA Receiver Equalization Adaptation
Usage Model section.
• Added sub-step to step 8 in the User-Defined Pattern Example section.
• Updated the sub-steps to step 10 in the PRBS Usage Model section.
2018.05.15
Made the following changes:
• Added the "User-Defined Pattern Example" section.
• Added a brief description and an example reconfiguration of a duplex PMA in the "Reconfiguring the
Duplex PMA Using the Reset Controller in Automatic Mode" section.
• Created and added "Reconfiguring the Duplex PMA Using the Reset Controller in Automatic Mode."
• Moved "PRBS Usage Model" and "PMA Receiver Equalization Adaptation Usage Model" to the
“Dynamic Reconfiguration Usage Examples” chapter.
• Added the "PMA Receiver Equalization Adaptation Flowchart."
• Added the "Equalizer Bits" figure.
• Added the "PRBS Bits" figure.
• Added error injection instructions to the "PRBS Usage Model" section.
2018.01.31 Initial release.
8. Dynamic Reconfiguration Examples
UG-20056 | 2019.02.04
Intel
®
Stratix
®
10 E-Tile Transceiver PHY User Guide
Send Feedback
164

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English