Figure 98. Loading PMA Configuration Register START_CAL
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Note: Bit 31 is always set to 1 to send the message.
Loopback
Option
0 = External
loopback
1 = Internal
loopback
PRBS Pattern Select [8:5]
0x0 = PRBS7
0x1 = PRBS9
0x2 = PRBS11
0x3 = PRBS13
0x4 = PRBS15
0x5 = PRBS23
0x6 = PRBS31
0xF = Disable PRBS
PMA
Configuration
Load Status
0 = No PMA
config to load
1 = Load PMA
config
Contiguous Adaptation Type
[3:2]
0 = Stop continuous adaptation
1 = Start continuous adaptation
Initial Adaptation Effort [1:0]
2 = Initial adaptation
Adaptation Selection
0 = Disable initial adaptation
1 = Enable initial adaptation
3 = Full Flow (initial and
continuous adaptation)
Figure 99. Loading PMA Configuration Register SET_OPERATION_MODE
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Note: Bit 31 is always set to 1 to send the message.
PRBS Pattern Select [4:1]
0x0 = PRBS7
0x1 = PRBS9
0x2 = PRBS11
0x3 = PRBS13
0x4 = PRBS15
0x5 = PRBS23
0x6 = PRBS31
0xF = Disable PRBS
Loopback
Option
0 = External
loopback
1 = Internal
loopback
OPCODE
SET_OPERATION_MODE = 0x13
Figure 100. Loading PMA Configuration Register CHECK_CAL_STAT
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Note: Bit 31 is always set to 1 to send the message.
0 = Return physical channel address of this caller
1 = Get adaptation status on return Native PHY IP
OPCODE
SET_OPERATION_MODE = 0x17
Refer to PMA Analog Reset, Set PRBS Mode and Internal or Serial Loopback, Start
Adaptation and Put PMA in Mission Mode, and Read the Physical Channel Number for
how to set registers 0x200 to 0x203.
Related Information
• Loading a PMA Configuration on page 163
9. Register Map
UG-20056 | 2019.02.04
Send Feedback
Intel
®
Stratix
®
10 E-Tile Transceiver PHY User Guide
185