Use the Native PHY IP core in the Intel Quartus Prime Pro Edition software to configure
the transceiver PHY for your protocol implementation. To instantiate the IP:
1. Select the Intel Stratix 10 device family.
2. Click Tools > IP Catalog to select the Intel Stratix 10 E-Tile Transceiver Native
PHY IP core.
3. Specify the IP parameters and configure the Native PHY IP core for your protocol
implementation using the Parameter Editor.
4. Use the Native PHY IP core to instantiate one of the following transceiver usage
modes:
• PMA Direct
• PMA Direct high data rate PAM4
Based on the transceiver configuration rule that you select, the Native PHY IP core
guides you to configure the transceiver appropriately.
5. After you configure the Native PHY IP core in the Parameter Editor, click
Generate HDL to generate the IP instance.
The top-level file generated with the IP instance includes all the available ports for
your configuration. Use these ports to connect the Native PHY IP core to the clock
network, the reset controller if you are not using Native PHY IP core's reset
controller, and to other IP cores in your design.
2. Implementing the Transceiver PHY Layer in Intel Stratix 10 Devices
UG-20056 | 2019.02.04
Intel
®
Stratix
®
10 E-Tile Transceiver PHY User Guide
Send Feedback
26
To Next Page
Loading...
