Juniper SRX5400 - MIC with 2 X40 Ge QSFP+ Interfaces (SRX-MIC-2 X40 G-QSFP)

MIC with 2x40GE QSFP+ Interfaces (SRX-MIC-2X40G-QSFP)
You use MICs and MPCs to add different combinations of Ethernet interfaces to your services gateway
to suit the specific needs of your network. The SRX-MIC-2X40G-QSFP (see Figure 51 on page 125) can be
installed in an MPC to add two 40-Gigabit quad small form-factor pluggable (QSFP+) Ethernet ports.
Figure 51: SRX-MIC-2X40G QSFP
g030311
LINK
PORT1
LINK
PORT0
•
MIC with two QSFP+ Ethernet ports
•
Fits into MPC
•
Supports up to 80 Gbps of full-duplex traffic
•
Maximum configurable MTU: 9192 bytes
•
Maximum throughput: 80 Gbps
Description
Junos OS Release 12.1X46-D10Software release
Sockets for two QSFP+ 40-Gigabit Ethernet fiber-optic transceivers.
Supported QSFP+ transceiver:
40GBASE-SR4 (model number SRX-QSFP-40G-SR4)
40GBASE-LR4 (model number SRX-QSFP-40G-LR4)
Cables and connectors
Either slot in SRX5K-MPCSupported slots
Approximately 1.6 lb (0.7 kg)Weight
OK/FAIL LED, one bicolor:
•
Green–The MIC is operating normally.
•
Red–The MIC has failed and is not operating normally.
•
Off–The MIC is powered down.
LINK LED, single color, one per QSFP+ port:
•
Green–The link is active.
•
Off–No link.
LEDs
125