admin@cluster> monitor interface traffic
•
To ensure sessions are created and deleted on the upgraded node, issue the following command:
admin@cluster> show security monitoring
14. Repeat Step 1 through 12 for the primary node.
15. To ensure that the ISHU process is completed successfully, check the status of the cluster by issuing
the following command:
admin@cluster> show chassis cluster status
For detailed information about chassis cluster, see the Chassis Cluster User Guide for Security Devices at
www.juniper.net/documentation/.
Maintaining the SRX5400 Line Cards and Modules
IN THIS SECTION
Holding an SRX5400 Services Gateway Card | 278
Storing an SRX5400 Services Gateway Card | 280
Replacing SRX5400 Services Gateway MPCs | 280
Replacing SRX5400 Services Gateway MICs | 286
Installing an MPC and MICs in an Operating SRX5400 Services Gateway Chassis Cluster | 290
Maintaining SPCs on the SRX5400 Services Gateway | 293
Replacing SRX5400 Services Gateway SPCs | 295
Replacing SPCs in an Operating SRX5400, SRX5600, or SRX5800 Services Gateways Chassis Cluster | 300
In-Service Hardware Upgrade for SRX5K-SPC3 in a Chassis Cluster | 303
277
To Next Page
Loading...
