Juniper SRX5400 - Configuring Interfaces, Zones, and Policies with J-Web

[edit]
root@# set system services web-management http
8. Commit the configuration changes.
[edit]
root@# commit
Configuring Interfaces, Zones, and Policies with J-Web
IN THIS SECTION
Configuring the Hostname | 217
Configuring Interfaces | 217
Configuring Zones and Assigning Interfaces | 218
Configuring Security Policies | 218
You can configure hostnames, interfaces, zones, and security policies using J-Web.
NOTE: You cannot use J-Web to configure SRX5400, SRX5600, and SRX5800 Services Gateways
in Junos OS Release 15.1X49-D10.
Before you begin:
•
Ensure you have configured the IP address, root authentication, and default route. See “Configuring
Root Authentication and the Management Interface from the CLI” on page 215
•
Enable HTTP on the device to access J-Web. See “Configuring Root Authentication and the Management
Interface from the CLI” on page 215
Configure the device with J-Web using the following procedures.
216