Juniper SRX5400 - Troubleshooting SRX5400 Services Gateway Spcs

user@host> show chassis fpc pic-status
Slot 0 Online SRX5k SPC II
PIC 0 Online SPU Cp
PIC 1 Online SPU Flow
PIC 2 Online SPU Flow
PIC 3 Online SPU Flow
Slot 1 Online SRX5k SPC II
PIC 0 Online SPU Flow
PIC 1 Online SPU Flow
PIC 2 Online SPU Flow
PIC 3 Online SPU Flow
Slot 2 Online SRX5k IOC II
PIC 0 Online 2x 40GE QSFP+
PIC 2 Online 10x 10GE SFP+
For further description of the output from the command, see Junos OS System Basics and Services Command
Reference at www.juniper.net/documentation/.
Troubleshooting SRX5400 Services Gateway SPCs
Problem
Description: A Services Processing Card (SPC) is not functioning normally.
Solution
•
Make sure the SPC is properly seated in the midplane. Check that each ejector handle has been turned
clockwise and is tight.
•
Issue the CLI show chassis fpc command to check the status of installed SPCs. As shown in the sample
output, the value Online in the column labeled State indicates that the SPC is functioning normally:
user@host> show chassis fpc
Slot State (C) Total Interrupt DRAM (MB) Heap Buffer
0 Online 35 4 0 1024 13 25
1 Online 47 3 0 1024 13 25
2 Online 37 8 0 2048 18 14
For more detailed output, add the detail option. The following example does not specify a slot number,
which is optional:
user@host> show chassis fpc detail
360