Replacing an SRX5400 Services Gateway Network Cable
IN THIS SECTION
Removing an SRX5400 Services Gateway Network Cable | 309
Installing an SRX5400 Services Gateway Network Cable | 310
Removing an SRX5400 Services Gateway Network Cable
Removing and installing network cables does not affect services gateway function, except that the
component does not receive or transmit data while its cable is disconnected.
To remove a fiber-optic cable from a MIC:
1. If the component connects to fiber-optic cable, have ready a rubber safety cap for each cable and
transceiver.
2. If removing all cables connected to a MIC, use one of the following methods to take the MIC offline:
•
Press the online/offline button on the port module. Use a narrow-ended tool that fits inside the
opening that leads to the button. Press and hold the button until the port module LED goes out (about
5 seconds).
•
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot port-module-slot offline
For more information about the command, see Junos OS System Basics and Services Command Reference
at www.juniper.net/documentation/.
3. Unplug the cable from the cable connector port. If the MIC uses fiber-optic cable, immediately cover
each transceiver and the end of each cable with a rubber safety cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
309
To Next Page
Loading...
Need help?
General
