Juniper SRX5400 - Replacing a Routing Engine: External SCP Server Method

root@node1> show chassis cluster status
Node 0 comes up and becomes the secondary node on both RG0 and RG1. Wait until the node 0
priority on RG1 changes to the configured value.
11. Verify that sessions are showing up on node 0, and that the number of sessions on node 0 is nearly
equal to the number of sessions on the primary node, node 1:
root@node1> show security monitoring
12. If the cluster is healthy, reset the cluster priorities:
root@node1> request chassis cluster failover reset redundancy-group 1
root@node1> request chassis cluster failover reset redundancy-group 0
Replacing a Routing Engine: External SCP Server Method
The following are the assumptions and prerequisites for this procedure:
•
Console access and SSH access are available.
•
The chassis cluster has only two redundancy groups (RG0 and RG1) configured.
This procedure includes the steps for replacing the Routing Engine on node 0 of a chassis cluster setup.
You can follow the same steps to replace the Routing Engine on node 1.
321