Juniper SRX5400 - Page 243

Uptime 3 hours, 27 minutes, 27 seconds
Load averages: 1 minute 5 minute 15 minute
0.44 0.16 0.06
•
To check the status of the SCB, issue the show chassis environment cb command. The output is similar
to the following:
user@host> show chassis environment cb
CB 0 status:
State Online Master
Temperature 40 degrees C / 104 degrees F
Power 1
1.2 V 1208 mV
1.5 V 1521 mV
1.8 V 1807 mV
2.5 V 2507 mV
3.3 V 3319 mV
5.0 V 5033 mV
12.0 V 12142 mV
1.25 V 1243 mV
3.3 V SM3 3312 mV
5 V RE 5059 mV
12 V RE 11968 mV
Power 2
11.3 V bias PEM 11253 mV
4.6 V bias MidPlane 4814 mV
11.3 V bias FPD 11234 mV
11.3 V bias POE 0 11176 mV
11.3 V bias POE 1 11292 mV
Bus Revision 42
FPGA Revision 1
To check the status of a specific SCB, issue the show chassis environment cb node slot command, for
example, show chassis environment cb node 0.
For more information about using the CLI, see the CLI Explorer.
246