Juniper SRX5400 - Page 266

24. Commit the configuration.
root@#commit
25. After the secondary node is up, verify that it synchronizes with the primary node.
admin@cluster#delete interfaces xe-4/0/5 disable
admin@cluster#delete interfaces xe-10/0/5 disable
26. Enable SYN bit and TCP sequence number checking for the secondary node.
admin@cluster#delete security flow tcp-session no-syn-check
admin@cluster#delete security flow tcp-session no-sequence-check
27. Commit the configuration.
root@#commit
28. Verify the Redundancy Group (RG) states and their priority.
root@cluster>show version
node0:
--------------------------------------------------------------------------
Hostname: <displays the hostname>
Model: <displays the model number>
Junos: 15.1X49-D10
JUNOS Software Release [15.1X49-D10]
node1:
--------------------------------------------------------------------------
Hostname: <displays the hostname>
Model: <displays the model>
Junos: 15.1X49-D10
JUNOS Software Release [15.1X49-D10]
After the secondary node is powered on, issue the following command:
root@cluster>show chassis fpc pic-status
269