Juniper SRX5400 - Page 338

Table 53: Chassis Component Alarm Conditions on SRX5400, SRX5600, and SRX5800 Services
Gateways (continued)
Alarm
SeverityRemedyAlarm Condition
Chassis
Component
To manually upgrade the
LTC Firmware Version:
1.
Issue the CLI show
chassis alarm
command to check
which FPC slot is
raising the LTC FW
Version Mismatch
alarm.
2.
Issue the CLI show
system firmware
command to check the
current LTC firmware
version, if a new
verision of LTC
firmware is available
for the SRX5K-SPC3
card, and the firmware
status is OK.
3.
If there is a new
version of LTC
firmware, issue the CLI
command request
system firmware
upgrade pic fpc-slot x
pic-slot x tag x to
upgrade the LTC
firmware on the
SRX5K-SPC3 card.
4.
Issue the CLI command
show system firmware
to confirm the status
of the SRX5K-SPC3
LTC firmware is
UPGRADED
SUCCESSFULLY.
342