•
Processor subsystem, which includes a 1.2-GHz CPU, system controller, and 1 GB of SDRAM.
•
LEDs on the faceplate that indicate the SPC and SPU status.
SPC with four SPUsDescription
•
Junos OS Release 12.1X44-D10 and laterSoftware
release
CHASSIS CLUSTER CONTROL 0 and CHASSIS CLUSTER CONTROL 1–SFP ports for control links
in chassis cluster configurations.
Supported SFP transceivers:
1000BASE-LH (model numbers SRX-SFP-1GE-LH, SRX-SFP-1GE-LH-ET)
1000BASE-LX (model numbers SRX-SFP-1GE-LX, SRX-SFP-1GE-LX-ET)
1000BASE-SX (model numbers SRX-SFP-1GE-SX, SRX-SFP-1GE-SX-ET)
Cables and
connectors
NoneControls
•
SRX5400–Any slot, except the bottom slot 0 which is reserved for SCB/RE.
•
SRX5600–Any slot, except the bottom slots 0 or 1 which are reserved for SCB/RE.
•
SRX5800–Any slot, except the slots 0 or 1 which are reserved for SCB/RE.
Supported Slots
475 W typical, 585 W maximum
NOTE:
•
In the SRX5600 and SRX5800 Services Gateways, you must have high-capacity power supplies
(either AC or DC) and high-capacity fan trays installed in the services gateway in order to install
and use SRX5K-SPC-4-15-320 SPCs. If you do not have high-capacity power supplies and fan
trays installed, the services gateway will log an alarm condition when it recognizes the
SRX5K-SPC-4-15-320 SPCs.
•
On SRX5600 Services Gateways with AC power supplies, we recommend that you use high-line
(220v) input power to ensure the device has adequate power to support SRX5K-SPC-4-15-320
SPCs.
Power
Requirement
Approximately 18 lb (8.3 kg)Weight
96
To Next Page
Loading...
