Keyscan Technical Guide (PC109x - 04.12)
154
Appendix F –WIEEX2 &
CWIEEX2
Appendix F reviews general information, installation guidelines, and connection diagrams for Keyscan RS485
Wiegand Extenders (WIEEX2) and COAX Wiegand Extenders (CWIEEX2). Wiegand extenders are used on doors
and readers that exceed the 500 feet maximum distance from the ACU. When installing the CWIEEX2 &
WIEEX2 extenders please check the version and observe the corresponding wiring diagram as indicated below.
Each type of Wiegand extender – CWIEEX2 and WIEEX2 – includes 1 transmitter and 1 receiver. The following
additional components may be required to complete the installation of Wiegand extenders:
• 12VDC 1Amp power supply with battery backup
• mounting interface enclosure
Important
Do not mix CWIEEX2 or WIEEX2 (firmware 6.00 or higher) receivers and transmitters with previous
generation CWIEEX or WIEEX (firmware 5.03 or lower) receivers and transmitters.
WIEEX2 & CWIEEX2 Functions
The following table outlines the functions and capabilities of CWIEEX2 and WIEEX2 extenders.
Table 28 – WIEEX2 & CWIEEX2
CWIEEX2 / WIEEX2 Functions/Capabilities
CWIEEX2 or WIEEX2 – (firmware 6.00 or higher) - 26 bits to 80 bits
- multi-baud rates 9,600 & 19,200
- supports Present3
- PIN keypad transmission
- 4 & 8 bit burst
Table 29 – WIEEX2/CWIEEX2 Power Requirements
Unit Power Notes
WIEEX2 Transmitter (Tx) 12 VDC, 50 mA
WIEEX2 Receiver (Rx) 12 VDC, 50 mA
CWIEEX2 Transmitter (Tx) 12 VDC, 50 mA
CWIEEX2 Receiver (Rx) 12 VDC, 50 mA
OCB-8 12 VDC, 230 mA Optional – An OCB8 is required when not switching a 12VDC door lock
or gate operator. See Figure 122 – WIEEX2 to OCB-8 Cable Connection
on page 159.
To Next Page
Loading...
Need help?
General
