136 Keysight E4980A/AL Precision LCR Meter
Configuring Measurement Conditions (Display and Function Related Settings)
LIMIT TABLE SETUP Page
4-
Figure 4-15 Parameter Swap Feature
To swap the primary and secondary parameters:
Step 1. Press [Meas Setup].
Step 2. Press the LIMIT TABLE softkey.
Step 3. Using the cursor keys, select the FUNC field.
Step 4. Press the SWAP PARAM softkey to swap the primary and secondary
parameters.
You can revert to the previous setting of primary and secondary parameters
by pressing the SWAP PARAM softkey again.
Using the parameter swap feature does not change the primary and
secondary parameters for the measurement function (on the MEAS
DISPLAY and MEAS SETUP pages).
To Next Page
Loading...
