Keysight E4980A/AL Precision LCR Meter 237
Overview of Remote Control
LAN remote control system
8-
Control via Web server
For control over a Web server, communications are performed between the
external controller and the E4980A/AL through a LAN, regarding the
E4980A/AL as a Web server. You can control the E4980A/AL and send SCPI
commands from the external controller by displaying the E4980A/AL’s front
panel in the external controller with Internet Explorer (IE6.0 SP2 or later).
In addition, you can import the screen and recall list measurement data.
Preparing External Controller
As in the case of the SICL-LAN server, you need to set the I/O interface of the
external controller in advance to establish communication to the E4980A/AL
using the TCP/IP protocol. For the procedure, refer to
“Preparing the external
controller” on page 230 of “Control over SICL-LAN server” section.
Control using web server
The following steps show how to control the E4980A/AL (IP address example:
10.116.199.134) using Internet Explorer.
Step 1. Start Internet Explorer.
Step 2. Type http://10.116.199.134/ in the address field and press the enter key.
Enter CURRENT IP ADDR on the E4980A/AL’s SYSTEM CONFIG page for an IP
address.
Step 3. The Web server’s start screen appears.
Figure 8-6 Web Server Start Screen
To Next Page
Loading...
