Keysight E4980AL - System:communicate:lan[:Self]:Current:smask; System:communicate:lan[:Self]:Dgateway; System:communicate:lan[:Self]:Dhcp[:State]

Keysight E4980A/AL Precision LCR Meter 373
SCPI Command Reference
E4980A/AL commands
10-
:SYSTem:COMMunicate:LAN[:SELF]:CURRent:SMASk?
Syntax :SYSTem:COMMunicate:LAN[:SELF]:CURRent:SMASk?
Description Returns the current Subnet Mask. (Query Only)
Equivalent key No equivalent key is available on the front panel.
:SYSTem:COMMunicate:LAN[:SELF]:DGATeway
Syntax :SYSTem:COMMunicate:LAN[:SELF]:DGATeway <String>
:SYSTem:COMMunicate:LAN[:SELF]:DGATeway?
Description Sets the static Gateway address.
Parameter
Equivalent key [System] - SYSTEM CONFIG - MANUAL GATEWAY - ENTER
:SYSTem:COMMunicate:LAN[:SELF]:DHCP[:STATe]
Syntax :SYSTem:COMMunicate:LAN[:SELF]:DHCP[:STATe] {ON|OFF|1|0}
:SYSTem:COMMunicate:LAN[:SELF]:DHCP[:STATe]?
Description Enables DHCP to obtain the IP address from a DHCP server.
Parameter
Equivalent key [System] - SYSTEM CONFIG - DHCP ENABLED - ON
[System] - SYSTEM CONFIG - DHCP ENABLED - OFF
<String>
Preset value "0.0.0.0"
This command works with Firmware version 1.0x. Do not use this
command with Firmware version 2.00 or later.
Description
ON or 1 (Preset value) Enables the DHCP function
OFF or 0 Disables the DHCP function