322 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
E4980A/AL commands
10-
E4980A/AL commands
This section describes the commands specific to the E4980A/AL.
*CLS
Syntax *CLS
Description Clears the following:
• Error Queue
• Status Byte Register
• Standard Event Status Register
• Operation Status Event Register
• Questionable Status Event Register (No Query)
Equivalent key No equivalent key is available on the front panel.
*ESE
Syntax *ESE <numeric>
*ESE?
Description Sets the value of the Standard Event Status Enable Register. Refer to the
chapter on Remote Control.
Parameter
Equivalent key No equivalent key is available on the front panel.
*ESR?
Syntax *ESR?
Description Reads out the value of the Standard Event Status Register. Executing this
command clears the register value. Refer to the chapter on Remote Control.
(Query Only)
Equivalent key No equivalent key is available on the front panel.
<Numeric>
Range 0 to 255
To Next Page
Loading...
