Keysight E4980AL - System:communicate:lan[:Self]:Address; System:communicate:lan[:Self]:Aip[:State]

Keysight E4980A/AL Precision LCR Meter 371
SCPI Command Reference
E4980A/AL commands
10-
Equivalent key [System] - SYSTEM CONFIG - GPIB ADDR
:SYSTem:COMMunicate:LAN[:SELF]:ADDRess
Syntax :SYSTem:COMMunicate:LAN[:SELF]:ADDRess <String>
:SYSTem:COMMunicate:LAN[:SELF]:ADDRess?
Description Sets the static IP address.
Parameter
Equivalent key [System] - SYSTEM CONFIG - MANUAL IP ADDR - ENTER
:SYSTem:COMMunicate:LAN[:SELF]:AIP[:STATe]
Syntax :SYSTem:COMMunicate:LAN[:SELF]:AIP[:STATe] {ON|OFF|1|0}
:SYSTem:COMMunicate:LAN[:SELF]:AIP[:STATe]?
Description Enables automatic IP address setup. The E4980A/AL can obtain an available IP
address at 169.254.xxx.xxx.
Parameter
Equivalent key [System] - SYSTEM CONFIG - AUTO-IP ENABLED - ON
[System] - SYSTEM CONFIG - AUTO-IP ENABLED - OFF
Resolution 1
<Numeric>
<String>
Preset value "192.168.1.101"
This command works with the firmware revision 1.0x. Do not use this
command with the firmware revision 2.00 or later.
Description
ON or 1 (Preset value) Enables automatic IP address setup
OFF or 0 Disables automatic IP address setup