-444 Keysight E4980A/AL User’s Guide
Error Messages
Error Messages
-
82 Store failed
This error may appear when you attempt to save data immediately after
inserting the USB memory into the E4980A/AL.
Suggestion:
You need to wait for a few seconds after inserting the USB.
83 No data to load
There is no setup data for the selected number. Or the USB memory is not
inserted. The checksum has failed.
Suggestion:
Check the USB memory is properly inserted or set proper settings.
83 Out of Memory
The E4980A/AL has insufficient memory to perform the requested operation.
90 Data buffer overflow
This error occurs when the amount of data exceeds the defined data buffer
memory size.
Suggestion:
If this error occurs during the measurement after pressing [Save/Recall] - SAVE
DATA - START LOG, press SAVE & STOP.
Hardware
1000 Power on test failed
An error occurs during the power-on test at start-up or a self test. An interface
board is removed or not connected properly or the E4980A/AL may be faulty.
Suggestion:
Check the connection with a cable when you change the setting of the
interface board. When the interface board connected properly, contact
Keysight Technology’s Sales and Service Office or the company from which you
bought the device.
1070 Fan failed
Cooling fan hardware failure is detected.
Suggestion:
When this error occurs, contact Keysight Technology’s Sales and Service Office
or the company from which you bought the device.
To Next Page
Loading...
