18 Keysight E4980A/AL Precision LCR Meter
Unpacking and Preparation
Checking the Shipment
1-
Checking the Shipment
After you receive the E4980A/AL, carry out checks during unpacking according
to the following procedure.
Step 1. Check that the packing box or shock-absorbing material used to package the
LCR meter has not been damaged.
Step 2. Check the packaged items supplied with the LCR meter for any damage or
defects.
Step 3. Referring to
Table 1-1 and Figure 1-1, check that all packaged items supplied
with the LCR meter have been provided as per the specified options.
Step 4. After checking, if one of the following applies, contact your nearest Keysight
Technologies sales and service office.
1. The packing box or shock-absorbing material used to package the LCR
meter has been damaged or the shock-absorbing material displays traces
of where extreme pressure has been applied.
2. A packaged item supplied with the LCR meter has mechanical damage or
defects.
3. A packaged item supplied with the LCR meter is missing.
4. A fault has been detected in the subsequent operation check of the LCR
meter.
If an abnormality is detected in Step 1, contact the company that transported
the LCR meter as well as your nearest Keysight Technologies sales and
service office. For inspection by the transport company, save the packing box,
shock-absorbing material, and packaged items as you received them.
If the external face of the LCR meter (such as the cover, front/rear panel,
LCD screen, power switch, and port connectors) appears to have been
damaged during transport, do not turn on the power switch. Otherwise,
you may get an electrical shock.
If the packing box or shock-absorbing material has been damaged, leave
the packing box and shock-absorbing material as is until other inspection
items are checked as follows:
To Next Page
Loading...
