364 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
E4980A/AL commands
10-
Description Clears and disables the data buffer memory. After this command is executed,
measurement data will not be stored in the data buffer memory until execution
of the :FILL command. (No Query)
Equivalent key [Save/Recall] - SAVE DATA - SAVE & STOP
This key is a combination of both
:MEMory:READ? and :MEMory:CLEar.
:MEMory:DIM
Syntax :MEMory:DIM DBUF,<numeric>
:MEMory:DIM?
Description Clears the data buffer memory, and sets the data buffer memory’s size. An
example of data buffer memory is shown in the chapter on program examples.
Parameter
Equivalent key No equivalent key is available on the front panel.
:MEMory:FILL
Syntax :MEMory:FILL DBUF
Description Enables the data buffer memory to store measurement data. After execution of
this command, all measurement data will be stored in the data buffer memory.
If this has already been enabled, this command will do nothing. (No Query)
Equivalent key [Save/Recall] - SAVE DATA - START LOG
:MEMory:READ?
Syntax :MEMory:READ? DBUF
Description Places the data in the data buffer memory into the output buffer. The output
format of this command is the same as the one for FETC:IMP?. In the preset
state, “9.90000E+37,+9.90000E+37,-1,+0” is returned the number of times
specified by
:MEMory:DIM. When the data buffer memory is not filled to the
specified size (specified by the :MEMory:DIM command),
“9.90000E+37,+9.90000E+37,-1,+0” remains for the rest of the data locations.
(Query Only)
<Numeric>
Range 1 to 201
Preset value 201
Resolution 1
To Next Page
Loading...
