258 Keysight E4980A/AL Precision LCR Meter
Overview of Remote Control
Data Buffer Memory
8-
Output Format of Data Buffer Memory
There are two formats returned by the :MEM:READ? DBUF command: ASCII
and BINARY. Each format is described below. For sample programs using the
data buffer memory (output format: ASCII and BINARY), refer to the chapter on
sample programs.
o ASCII Format
Figure 8-18 below shows the output format when the ASCII format is
selected as the data format. The data format and meaning of <DATA A>,
<DATA B>, <STATUS>, <BIN No.>, or <IN/OUT> are the same as those of the
ASCII data format described in Data Format of “Data Transfer” on page 264
The exponent part for <DATA A>, <DATA B> can be change to 3 digit by the
command of :FORM:EXP:DIG
Figure 8-17 ASCII format (Buffer memory)
o BINARY Format
Figure 8-19 shows the output format when the BINARY format is selected
as the data format. The data format and meaning of <DATA A>, <DATA B>,
<STATUS>, <BIN No.>, or <IN/OUT> are the same as those of the BINARY
data format described in Data Format of “Data Transfer” on page 264
To Next Page
Loading...
